The Garrett ACE 300 metal detector is a Continual Wave single frequency device operating at 8 kHz. Its frequency is adjustable by four minor levels that is a feature the ACE 200 does not have. While you may not have use for this function, it’s convenient to have when power lines or other metal detectors in competitions start to interfere. It’s a surface exploration metal detector that is rated to detect items at about 8” deep, but it has the potential to detect deeper depending on target chemistry and size, the soil, and your settings. However, due to its limitation of having factory-set ground balance, it may not perform well in high-mineralization environments. With its Target ID, various detection modes, built-in pinpointer, and adjustable settings, it has more than enough for a novice to get started with. Combine quality and decent features together, the ACE 300 will keep an intermediate hobbyist interested and hunting for many expeditions to come.
Eliminate or minimize interference caused by electrical sources or from other metal detectors (such as at crowded club hunts, rallies).
Find out more about key features and the technology behind the ACE 300™ by clicking on the buttons below.
Numeric identification scale from 0 to 99. Identifies a target metal’s conductivity.
This non-motion All-Metal Mode function is used to precisely locate a detected target’s position.
Increased resolution (more pixels) allows more precise control of how much iron discrimination to apply. Very useful in areas where desired treasure targets are being masked by iron trash.
Simultaneously shows a treasure target’s conductivity and the detector’s discrimination pattern.